Pioneer ANH-P10MP Manual De Instrucciones página 23

Setting the Navigation
7 After installing the language, you have to
wait for GPS reception before commencing
the calibration journey.
Notes
• During the check, the vehicle must be out-
doors and the GPS aerial must have a clear
view of all directions. It may take a few min-
utes until sufficient GPS reception is avail-
able. The next display appears during this
period. A calibration journey is requested
when sufficient GPS reception is available.
• In order to minimise the waiting period for
sufficient GPS reception, the vehicle should
not moved during this time. The unit must be
switched on.
8 Before commencing the calibration jour-
ney, the sensor tests should be carried out.
To invoke service garage mode, press multifunc-
tion button and simultaneously.
3 5
9 The calibration journey can be com-
menced after successful completion of the
tests.
Service garage mode is quit by repeatedly press-
ing the button.
NAVI/OK
Notes
• The calibration journey should not take place
on a motorway, but should include as many
turnings as possible. The next display appears
during the calibration journey.
• When calibration status 2 has been reached,
the main navigation menu is displayed and
the unit is ready for operation. Final precision
is only achieved after a further journey (cali-
bration status 3).
• If the unit is switched off during the calibra-
tion journey, language installation is
requested when the unit is switch on again.
To proceed with reinstallation, press the
button.
NAVI/OK
• For correct navigation on routes with time-
dependent traffic guidance, the time should
be correctly set as described under System
settings in the operation manual.
22
En