Calibration; Deleting The Calibration; Calibration Setting - Pioneer ANH-P10MP Manual De Instrucciones

Setting the Navigation

Calibration

Calibration
After commissioning , a calibration journey is
required. During the journey, the speedometer
signal is adapted to the vehicle-specific data
and the gyro sensors are adapted to the installa-
tion position of the unit.
The distance to be covered depends on the type
of vehicle and the local conditions.
Note
• The navigation system is only ready for opera-
tion on completion of the calibration journey.
The main navigation menu is displayed. Final
precision is only achieved after a further jour-
ney (calibration status 3).
1 In service garage mode, select
using the rotary stick and press to
TION RIDE
confirm.
The calibration status (e.g.
type of locationing (e.g.
completing calibration, the street in which you
are currently driving is displayed (provided that
it is digitised) instead of
CALIBRA-
) and the
STATUS: 2
) are displayed. After
3D
and .
WHEEL REVERSE

Deleting the calibration

If the navigation system is removed from one
vehicle and installed in another vehicle, it must
be calibrated. However, to do so, the current
calibration data must be deleted.
1 In service garage mode, select
using the rotary stick and
CALIBRATION
press to confirm.
2 Using the rotary stick, select
press to confirm.
The calibration is deleted and the unit returns to
service garage mode.

Calibration setting

Note
• Calibration settings should only be made
when the values to be entered are known. The
unit cannot make correct route calculations if
incorrect values are entered.
1 In service garage mode, select
using the rotary stick and
CALIBRATION
press to confirm.
and
DELETE
26
En