Setting The Navigation Calibration - Pioneer ANH-P10MP Manual De Instrucciones

Setting the Navigation
Calibration
Before using the navigation, perform calibration
and language definition referring to the
Installation Manual.
After switching on the unit, the status of the
GPS antenna or of the GPS reception will be
indicated on the right of the display. Four differ-
ent messages may appear:
• : The navigation CD can be inserted.
GPS OK
GPS reception is already available.
• It is necessary to wait for GPS
GPS WAIT:
reception. Waiting is required until
displayed (vehicle must be outdoors). The
navigation CD can be inserted.
•
GPS ANTENNA ERROR:
not properly connected.
•
GPS MODULE ERROR:
played, please contact your local Pioneer
dealer.
21
En
is
GPS OK
The GPS antenna is
If this message is dis-
1 Insert the navigation CD to install the
software for the navigation system.
2 After installing the navigation software,
press the button.
NAVI/OK
The next display appears.
3 Press the button to access the
BACK
system settings.
The language selection is then requested.
4 Select the language using the rotary
stick.
The language selection is confirmed by press-
ing the button and the language is
NAVI/OK
installed.
5 Select the voice using the rotary stick.
You can choose either a male or a female voice
for some languages.
The voice is confirmed and installed by pressing
the button.
NAVI/OK
6 After installation, press the
ton to confirm.
but-
NAVI/OK