[Zoom] Settings - Rollei 56 Manual De Instrucciones

[ZOOM] Settings

Press the 'ZOOM button' so that the number in the first row is highlighted .
Press the left and right button to set the appropriate value .
Press the 'ZOOM button' again to exit the setup state .
A
Automatic
About Automatic Zoom A and Manual Zoom M Settings:
Flash head automatically zoom: Press the left and right button to adjust the
flash range . If "A" is displayed, the flash will automatically adjust the flash covera-
ge (boot initialized to 35 mm) . If the flash is mounted on cameras supporting E TTL
and I TTL, the flash bulbs will change accordingly as the lens zoom is moved . If the
built-in reflector bounce card is taken out, the zoom will automatically changed to
14mm, as it is a wide angle flash . This cannot be changed manually or by changing
the camera zoom .
Manually set the lamp holder zoom position:
Press the left and right buttons to adjust the flash range . If "M" is displayed, you
can manually adjust the flash coverage (18,24,28,35,50,70,85,105,135,180) .
If zoom is adjusted manually, please ensure that the flash coverage
covers the lens zoom, so that the picture will not show the edge of a
shadow.
M M M
18 24 28
M M M
35 50 70
M M M
85 105 135
59
M
180