Signal Tones - Rollei 56 Manual De Instrucciones

2. Wireless optical flash
73
If the built-in flash light or an outlay flash light is used as MASTER flash light, place
flashes in different angels . The wireless channel will be reflected back by the wall
indoor . So please choose more space between flash light .
Due to a higher sensor sensitivity the wireless trigger sensing does have a distance
of up to 15 meters when using the S1 or S2 mode outside . If a slave Flash Unit is
used, test the S1 or S2 mode whether it is synchronous before shooting .
Note: Don't put any barriers between the master and slave Flash Unit . The barrier
will prevent to send a wireless light signal .
Make sure that the optic control sensor is towarded to the master Flash Unit .
The Flash Unit should not be used under sunshine .
Setting Position and Operation range
Outdoor Indoor Outdoor Indoor

Signal Tones:

Different sounds are used to indicate different working conditions .
Press the "Function button" for a long time to enter the custom settings .
1 . A long ring: call back to complete
2 . Two short rings: on or call back to complete normal flash
3 . Two long rings: flash call back unfinsihed
4 . Five short rings: the battery power is not enough or call back timeout
5 . Continuous buzz : flash light overheating and come into overheating protection
The display will show the icon