Full Instruction Master Unit (I-Ttl Full Atuo, Master, Nikon)/ Manual Instruction Master Unit (M, Manual, Master, Nikon) - Rollei 56 Manual De Instrucciones

Full instruction MASTER unit (i-TTL Full Atuo, MASTER,
Nikon )/Manual instruction MASTER unit
(M, manual, MASTER, Nikon)
If the MASTER unit is in TTL or M mode you can use the SLAVE UNIT in the
following modes: Wireless Flash OFF, TTL-Mode and M-Mode .
1 . Press the [button A] to set up Nikon MASTER unit (MASTER Nikon)
2 . Press the [Flash mode select button] to set up Full Auto iTTL Mode or Manual
Mode on the master flash .
3 . Wireless instruction flash mode .
Group A: Press the [zoom button] to (A) so that Group A power is highlighted .
Press the left and right button to change group A mode between wireless off, i-TTL
and M . If the setting is done, press the [zoom button] again to quit the group A
setting and go into group B setting .
Group B: Press the [zoom button] to (B) so that Group B power is highlighted .
Press the left and right button to change group B mode between wireless off, i-TTL
and M . If the setting is done, press the [zoom button] again to quit the group B
setting and go into group C setting .
Group C: Press the [zoom button] to (C) so that Group C mode is highlighted . Press
the left and right button to change group C mode between wireless off, i-TTL and
M . If the setting is done, press the [zoom button] to quit .
If the slave flash light group setting is done, it can be turned on or off .
ON: The wireless flash mode group number will be shown on the display .
OFF: The wireless group number won't be shown on the display .
4 . SLAVE unit power setting
Press the [center button] to <A> so that the group power is highlighted (if
group A is in wireless mode) . Press the left and right button to set the power .
Afterwards press the center button of the keypad to enter other group settings .
67