Flash Bracketing (Feb) - Rollei 56 Manual De Instrucciones

Flash bracketing (FEB)

51
By using FEB the flash exposure will be automatically changed, which helps in
conditions of invariable background exposure . You can take three flash shots while
automatically changing the flash output according to 1/3 to plus or minus .
After the FEB is done, the flash will go back to the standard settings that have been
used before . (This can be turned off in the custom settings .)
For using FEB set your camera into the mode "single shot" and ensure that the flash
is ready . Connect the Canon camera and set on the flash exposure value surrounded
exposure .
If a Nikon camera is connected the flash exposure information will not be shown of
the flash . You need to refer to the camera set .
FEB Setting Surrounded by Exposure Value
(effective for Canon cameras only )
Press the up and down button of the keypad to set FEB . The exposure value range is
0 to 3 .0 as shown in the table below .
0 0.3 0.7 1.0 1.3 1.7 2.0 2.3 2.7 3.0