Multi Wireless Master Unit (Multi, Master, Canon) - Rollei 56 Manual De Instrucciones

Set the flash output:<RATIO A:B> or <RATIO A:B:C>
64
Press the center button repeatedly until group A is highlighted on the display . Press
the right and left button to adjust group A power .
Press the center button repeatedly until group B is highlighted on the display . Press
the right and left button to adjust group B power .
Press the center button repeatedly until group C is highlighted on the display . Press
the right and left button to adjust group C power .

Multi Wireless MASTER Unit (Multi, MASTER, Canon)

Press the [Flash mode select button] to set the MASTER light into Multi mode .
You can set up each SLAVE unit in different flash light ratios . Use the MASTER unit
to finish all settings (SLAVE unit mode and MASTER unit mode is the same) .
Select flash light ratio
Press the left and right button to set the flash ratio: <RATIO OFF>, <RATIO A: B> or
<RATIO A: B: C> .
<RATIO OFF> means three SLAVE units will take the same mode and power output
as the MASTER unit . Press the mode button to set power output .
<RATIO A: B> means group A/B flashes and the power output needs to be set for
each single flash of the group .
<RATIO A: B: C> means three groups all on and will flash but the power output
needs to be adjusted for each single flash .
ENGLISH