Manual Wireless Master Unit (M, Manual, Master, Canon) - Rollei 56 Manual De Instrucciones

8:1 4:1
5 .6:1
6 . Set group C exposure compensation <RATIO A: BC>
Press the center button of the keypad repeatedly until group C compensation
will be highlighted . Adjust the value by using the left and right buttons and set
and quit the setting by pressing the center button .
If the SLAVE unit of group C is directed towards the subject, the subject will be
excessively exposed .

Manual Wireless MASTER Unit (M, Manual, MASTER, Canon)

Press the [Flash mode select button] to set the MASTER light into manual mode .
You can set up each slave unit in different flash light ratios . Use the MASTER unit to
finish all setting (SLAVE unit mode and MASTER unit mode is the same) .
Select flash light ratio
Press the left and right buttons to set the flash light ratio: <RATIO OFF>,
<RATIO A: B> or <RATIO A: B: C> .
<RATIO OFF> means three SLAVE units will take the same mode and power output
with the MASTER unit . Press M mode to set the power output .
RATIO A: B> means group A/B will flash and the power output of the flash in group
A/B will be adjusted on the single flash . <RATIO A: B: C> means three groups all on
and the power output can be adjusted on all single flashes .
2:1 1:1
2 .8:1 1 .4:1
1:2 1:4
1:1 .4 1:2 .8
1:8
1:5 .6
63