Seat Assembly; Mounting And Connecting The Battery; Mounting The Grass Catcher Supports; Removing The Grass Catcher Retaining Pawl - Stiga TC-TS-TX-TH 102 Serie Traducción Del Manual Original

Tabla de contenido

Publicidad

4.3 SEAT ASSEMBLY

Pull the regulator lever up (fig. 4.C) and 
slide the seat (fig. 4.A) into the guide (fig. 
4.B) from the steering wheel side, until 
it clicks into one of the six positions.
At this point, the seat has been mounted 
securely, so that it cannot be removed again 
without pressing the release lever (fig. 4.D).
4.4 MOUNTING AND CONNECTING
THE BATTERY
The battery (fig. 5.A) is housed under the 
seat and secured by a spring (fig. 5.B).
1. First connect the red wire (fig. 5.C) to 
the positive pole (+) and then the black 
wire (fig. 5.D) to the negative pole (–), 
using the screws supplied as shown. 
2. Mount the battery retaining spring (fig. 5.B), 
making sure that the cables are routed 
correctly in front of the battery, so that they 
are not pinched by the spring (fig. 5.B).
IMPORTANT Always fully
charge the battery according to the
instructions in the battery booklet.
IMPORTANT To avoid tripping the electronic
board protection device, never attempt to start
the engine if the battery is not fully charged!
4.5 MOUNTING THE GRASS
CATCHER SUPPORTS
Mount the two supports (fig. 6.A) on 
the rear plate (fig. 6.B), using the three 
screws (fig. 6.C) supplied for each 
support, as indicated, without locking 
the corresponding nuts (fig. 6.D).
Fasten the upper part of the grass catcher
frame (fig. 6.E) to the supports, and centre it 
with respect to the rear plate (fig. 6.B).
Adjust the position of the two supports (fig. 
6.F) with respect to the stop (fig. 6.G) so 
that, by rotating the grass catcher frame, the 
stud (fig. 6.H) fits into the housing correctly 
(fig. 6.I).
Check again that the frame (fig. 6.E) is 
centred correctly with respect to the rear 
plate (fig. 6.B) and that it rotates correctly, as 
described above, then tighten the fastening
screws (fig. 6.C) and nuts (fig. 6.D).
4.6 REMOVING THE GRASS
CATCHER RETAINING PAWL
When the machine is shipped the grass 
catcher retaining catch (fig. 7.A) is secured to 
the rear plate by means of the hook (fig. 7.B).
This must be removed before mounting 
the grass catcher bag supports
and may no longer be used.

4.7 MOUNTING THE REAR BUMPER

• Type "I" bumper
• Type "II" bumper
1. Mount the front bumper (fig. 8.A) on 
the lower part of the frame (fig. 8.B) 
using the four screws (fig. 8.C).
EN - 8

Publicidad

Tabla de contenido
loading

Tabla de contenido