Transportation; Storage; Care And Maintenance - Kärcher VC 4s Cordless Manual Del Usuario

Optional accessories
 Attach the mattress nozzle to clean
mites / dust in the mattresses and pil-
lows, etc.
 Attach the dusting brush to clean wall
surfaces, curtains, gaps in furniture, etc.
You need to use the flexible hose to con-
nect the dusting brush and the handy
vacuum cleaner.
 Attach the car nozzle to clean dirt / dust
in the car, etc.
You need to use the flexible hose to con-
nect the car nozzle and the handy vacu-
um cleaner.
Illustration O

Transportation

The battery has been tested in accordance
with the relevant rules for international
transport and can be transported / shipped.

Storage

Note
 Store the appliance in a dry room.
 Consider the weight of the appliance
when storing it.
1. Insert the appliance into the storage
dock.
Illustration P
2. Put the crevice nozzle and the upholster
brush into accessory storage.

Care and maintenance

Note
 Use the appliance only when all filters
and the dust container are installed.
 Defective filters and filters that can no
longer be cleaned must be replaced.
Before doing any work on the appliance:
1. Switch off the appliance.
2. Unplug the power supply from the power
outlet.
Cleaning the filter set and the dust
container
ATTENTION
Incorrect cleaning of the HEPA filter set
Damage to the HEPA filter set
Do not clean the HEPA filter set in a wash-
ing machine.
26
Do not dry the HEPA filter set with a hair
dryer.
The HEPA filter set ensures clean exhaust
air.
 Clean the HEPA filter set if it is visibly
dirty.
 Replace the HEPA filter set if it is visibly
damaged.
 We recommend replacing the HEPA fil-
ter set every 6 months based on your
use of the device.
1. Unlock the dust container, and pull out
the dust container.
Illustration Q
2. Remove the HEPA filter set, and unplug
the cyclone body and cyclone filter from
the dust container.
Illustration R
3. Carefully empty / knock the dirt out of the
HEPA filter set.
Illustration S
4. Empty the dust container, and rub down
the inside it using a cloth.
Illustration T
5. Turn the cyclone body counterclock-
wise, and separate the cyclone body
from the cyclone filter.
Illustration U
6. Clean the HEPA filter set, cyclone body,
cyclone filter and dust container under
running water.
Illustration V
7. Allow the HEPA filter set, cyclone body,
cyclone filter and dust container to dry
completely.
Illustration W
8. Insert the cyclone body into the cyclone
filter, and turn the cyclone body clock-
wise to latch into place.
9. Insert the cyclone set into the dust con-
tainer.
10.Install the HEPA filter set on the upper
section of the cyclone set, and align.
11.Align the mounting point on the appli-
ance with the desired mounting hole on
the dust container, and latch the dust
container into place.
Illustration X
English