GLOBBER ONE K Manual Del Usuario página 11

- Batteries contain dangerous substances. Do not attempt to open the battery or to insert any solid or liquid substance into the
battery or into the body of the appliance.
- Only Globber is authorised to repair the appliance.
- Using the battery is subject to authorisation by the local authorities.
9 - MAINTENANCE
Unplug the power and turn off the product before servicing. Monthly maintenance and inspection of the product is
required.
Warning. As with any mechanical component, your product is subject to high stresses and wear. The various mate-
rials and components may react differently to wear or fatigue, despite the evaluation of the resistance and fatigue
tests of the product according to EN14619. If the expected service life for a component has bee exceeded, it may
break suddenly, therefore risking causing injuries to the user. Cracks, scratches and discoloration in the areas subject
to high stresses indicate that the component has exceeded its service life and should be replaced.
Caution: the front wheel has a motorised part which can only be dismantled or changed by a qualified technician.
Do not change any motorised parts yourself or the warranty will be invalidated. Contact your dealer for a qualified
technician or contact Globber, contact@globber.com . Replacement of spare parts must be done with original parts
to avoid any impact on the health and safety of the user.
The lithium battery: To guarantee the battery lifetime, charge it appropriately when its level is low. If it is not used after long
of time, you are advised to charge it once a month. If you wish to check the battery or change it, contact a qualified technician
or a Globber representative.
The recommended storage temperature for the battery is between 5°C and 30°C.
Do not use or place the electric scooter in an environment where the temperature exceeds 40°C to avoid any lithium battery
malfunction which may lead to it catching fire.
Never store the electric scooter in a car during hot weather to avoid any danger of this.
Bearings: avoid riding through water, oil or sand which would damage your bearings. To maintain your bearings, check
regularly that the rear wheel turns properly by turning the electric scooter upside down and pushing the wheel with your
fingers. If the rear wheel does not turn, remove it and check the condition of the bearings. First unscrew the wheel axle.
Remove the axle and remove the wheel. Carefully push the two bearings out of their seating. If they are chipped or crushed,
buy new ones. If there is no visible damage, oil them. To do so, remove any traces of grease, mud or dust from the bearing
using a paper towel or a cloth then grease them either with a self-lubricating spray or by soaking them in oil overnight (turn
the bearings several times in the oil before leaving them to soak). Refit the bearings and axle, then the rear wheel.
The wheels: the wheels wear out after a certain length of time or may even develop holes if the scooter is used on rough sur-
faces too much. This is particularly true of the rear wheel on which the brake is applied. Check them regularly, check monthly,
and have them changed for better safety.
Product modifications: under no circumstances may the original product be modified apart from the maintenance stated
in these instructions.
Nuts, axles and other self-locking fasteners: check them regularly, check monthly. They may become loose over time. If
they do, tighten them up. They may also become less effective. In this case, replace them with new ones.
ENGLISH FRANÇAIS
11