Publicidad
ENGLISH
Description of control panel
The ZL16 electric panel is suitable for
controlling one automation of WINNY
24V series swing gates.
230V power supply with up to 100W
power and 50-60 Hz frequency.
Wholly designed and built by CAME
S.p.A., it meets UNI 8612 regulations in
force. ABS Case with an IP54 protective
level, with air recycling inlet and trans-
former.
The circuit requires 230V (a.c.) at termi-
nal blocks L1- L2 and the inlet is pro-
tected with one 1A fuse, whilst the low
voltage command devices are protected
by a 3.15A fuse.
The accessories' total wattage (24V)
must not exceed 40W.
The panel includes a amperometric
safety device for motor, that immediately
stops movement if gate hits an obstacle.
Safety
Photocells can be connected to obtain:
- Re-opening during closure (2-C1), if
the photocells identify an obstacle while
the gate is closing, they will reverse the
direction of movement until the gate is
completely open;
- Total stop (1-2), shutdown of gate
movement without automatic closing; a
pushbutton or radio remote control must
be actuated to resume movement).
Accessories which can be connected
- 12V-15W electric lock , connect it to ter-
minal blocks 1-ES.
-2-
GENERAL CHARACTERISTICS
Other functions
- Automatic closing (see bridge
connection S2). The automatic closing
timer is automatically activated at the
end of the opening cycle. The preset,
adjustable automatic closing time is
automatically interrupted by the
activation of any safety system, and is
deactivated after a STOP command or in
case of power failure;
- "Operator present" (see bridge
connection S1). Gate operates only
when the pushbutton is held down (the
radio remote control system is
deactivated);
Adjiustments
- Operating time;
- Automatic closure time;
- Amperometric sensitivity
Caution! Disconnect the unit from
the main power lines before carrying out
any operation inside the unit.
Publicidad
