General Characteristics - CAME Z Serie Manual Del Usuario

ENGLISH
Description of control panel
The ZBX6 control board is used as a
remote control for BX-A/BX-B series
230V single-phase automated sliding
gates.
The board is introduced and fixed in
place in the gearmotor's circuit board
holder (see assembly description on
page 6), at 230V (a.c.) in terminals L1
and L2.
The inlet is protected with two 5A fuses,
while the low voltage (24V) control
devices are protected with a 1A fuse.
The accessorie's total capacity (24V)
should not exceed 20W.
Fixed operating time of 80 seconds.
Photocells can be connected to abtain:
- Re-opening during closure (2-C1), if
the photocells identify an obstacle while
the gate is closing, they will reverse the
direction of movement until the gate is
completely open;
-2-

GENERAL CHARACTERISTICS

Safety
- Total stop (1-2), shutdown of gate
movement without automatic closing, a
pushbutton or radio remote control must
be actuated to resume movement.
Other functions
- Automatic closing. The automatic
closing timer is automatically activated
at the end of the opening cycle. The
preset, adjustable automatic closing
time is automatically interrupted by the
activation of any safety system, and is
deactivated after a STOP command or
in case of power failure;
- "Operator present" . Gate operates only
when the pushbutton is held down (the
radio remote control system is
deactivated);
Adjiustments
- Automatic closure time;
IMPORTANT: Disconnect the unit from
the main power lines before carrying out
any operation inside the unit.