ProMed 4030 SX Instrucciones De Empleo página 24

O
PERATING THE UNIT
Attention:
It is possible to still use the device despite an overfilled dust bag, but this will be at your own risk!
Attention:
It is absolutely necessary to ensure not only to actuate the "Reset" function, but also to replace the
dust bag in advance!
Attention:
The dust bag control system only serves as guidance. It does not check the actual status of the dust
bag. Only the operating time set is counted down step by step.
N. Setting the filter time
• The number of hours that are counted down until dust bag replacement is recommended can be set
individually based on your own experience from 10 up to a maximum of 20 hours.
• Press the button (R) and keep it pressed to set the operating hours. "SAVE" is shown on the display.
• The current operating hours are then displayed.
DE
EN
• Release the button (R) for a moment and press it again. Then, the range for setting the operating hours
(10 h – 20 h) appears on the display:
FR
IT
• The operating hours can be increased by pressing the button (L) or reduced by pressing the button (N).
Pressing the buttons and keeping them pressed, the display will enter the fast-forward mode.
• As soon as you have set the desired operating hours and do not make any further settings, the "standard
reading" is shown again on the display. The operating hours set are saved automatically.
ES
O. Foot switch or continually adjustable pedal (options):
Available accessories include a foot switch (ON/OFF), or a continually adjustable pedal. They are
NL
connected to the device via the "foot switch" socket (P) at the rear of the device.
• 1. Foot button (ON/OFF):
Let the device activated with a simple foot switch, i.e. the adjusted set values for speed and suction are
released by pressing the foot button. The removal of foot from the button leads to stopping the hand piece
RU
and suction turbine.
• 2. A continuously variable pedal (rocker pedal):
The speed can be controlled very smoothly and delicately with the pedal. The settings are adjusted with
the buttons (E) and (F) here as "pre-selection" and maximum position. The regulating possibility by foot
PL
is thus limited to a set speed in the Display. Taking your foot off the pedal stops both the motor and the
suction.
SE
Please note:
The function of the microswitch on the handpiece is not affected when the foot pedal is operated. Using the
microswitch, you can switch the device to the standby mode at all times.
FI
Note: Only Promed foot pedals can be used.