Grafik Eye - Lutron GRAFIK Eye GRX-IO Instrucciones De Instalación

Mounting
1. Mount the Control Interface directly on a wall, as shown
in the Mounting Diagram, using screws (not included).
When mounting, provide sufficient space for connecting
cables.
The unit can also be placed in the LUT-19AV-1U AV
rack using the screws provided with the unit. The
LUT-19AV-1U will hold up to four units.
If conduit is desired for wiring, the LUT-5x10-ENC can
be used to mount one unit.
2. Strip 3/8 in. (10 mm) of insulation from wires. Each Data
Link terminal will accept up to two #18 AWG
2
(1.0 mm ) wires.
3. Connect wiring as shown in the Wiring Diagram (next
page). STAT LED blinks once per second when properly
connected, and once every seven seconds when data
link is installed incorrectly.
Dimensions
3.75 in.
(95.3 mm)
1.06 in.
(26.9 mm)
2

GRAFIK Eye

and GRAFIK Systems Installation Instructions
®
2.50 in.
Mounting
(63.5 mm)
Holes
5.26 in.
(133.6 mm)
Mounting Diagrams
Wall
Control Interface
4.26 in.
(108.2 mm)
LUT-19AV-1U
LUT-5x10-ENC
Wire Strip Length
3/8 in.
3/8 in. (10 mm)
(10 mm)
R