Cleaning The Dust Container; Cleaning The Electrobrush/Handheld Brush - Miele HS19 Instrucciones De Funcionamiento

en-US
 Replace the pre-filter in the dust con-
tainer.
 To do this, line up the guide lines on
the two sections and turn the dust
container lid back to its original posi-
tion.
 Close the cover at the bottom of the
dust container, making sure it clicks
into place.
 Replace the fine dust filter.
 Replace the dust container on the
PowerUnit connector.

Cleaning the dust container

Clean the dust container as required.
 Remove the dust container.
 Empty the dust container over a trash
can and lift the pre-filter upwards to
remove it (Fig. 36).
 Clean the dust container using water
and liquid dish soap.
 Dry the dust container carefully.
 Replace the pre-filter in the dust con-
tainer.
 Replace the dust container on the
PowerUnit connector (Figs. 38 + 39).
Cleaning the Electrobrush/handheld
brush (Fig. 06)
(The availability of the handheld brush
depends on the model)
 Separate the Electrobrush/handheld
brush from the vacuum cleaner con-
nection.
24
Removing threads and hairs (Fig. 40)
 Place the Electrobrush/handheld
brush upside down on a level, clean
surface.
 Use a pair of scissors to cut any
threads or hairs that have wound
themselves around the roller brush.
To guide the scissors, move along the
guide track on the roller brush.
Then run the vacuum cleaner to vac-
uum up the cut threads and hairs.
Removing the roller brush (Fig. 41)
(Not possible with the handheld brush)
You can take the roller brush out of the
Electrobrush in order to remove stub-
born soiling and clean the inside of the
Electrobrush.
 Unlock the flap on the side of the
Electrobrush so that the  symbol
becomes visible.
 Lift the flap up as far as it will go.
 Remove the roller brush.
 Clean the roller brush and remove
any stubborn dirt inside the Electro-
brush.
 Reassemble the Electrobrush in re-
verse order.