Publicidad
Idiomas disponibles
Idiomas disponibles
6. Spray pre-mask side, so squeegee will glide smoothly over
film surface.
7. If properly positioned, begin to squeegee the film using
OVERLAPPING STROKES to remove all the air and fluid
from beneath the film. If not properly located, remove from
vehicle, re-spray with fluid and reposition.
8. Continue to squeegee until the film completely conforms to
the body and all fluid and air bubbles have been removed.
(See Figure 3)
FIGURE 3
9. Once the film has been applied to the vehicle, remove the
pre-mask by pulling against the surface at 180 degrees in
other words, back against itself (See Figure 4.) IF YOU
DON'T PULL THE PRE-MASK BACK AGAINST ITSELF, IT
WILL PULL THE FILM FROM THE VEHICLE, CREATING
AIR BUBBLES THAT WILL BE DIFFICULT TO RESEAL.
FIGURE 4
10. After pre-mask has been removed, re-squeegee all edges to
confirm adhesion.
Rear Bumper Protective Film
ALL INFORMATION WITHIN
DATE
ABOVE BORDER TO BE PRINTED
EXACTLY AS SHOWN ON 8.5 x 11
WHITE 16 POUND NON-BOND
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
ING TEMPLATES.
TO BE UNITIZED IN ACCOR-
DANCE WITH GMSPO SPECIFI-
CATIONS.
REVISION
AUTH
PART NO.
IR 18AU08
INSTALLATION INSTRUCTIONS
DR
TITLE
Rear Bumper Protective Film
PART NO.
19201150
6200 Grand Pointe Dr., Grand Blanc, MI 48439
19201150
SHEET
3
SHEET
3
9
OF
9
OF
Publicidad
