Installation; Before The Installation; Attaching The Seal; Built-In Hobs - Electrolux EHL9530FOK Manual De Instrucciones

16 www.electrolux.com
comes on. Make sure, you operated the
hob correctly. If not the servicing by a
service technician or dealer will not be
free of charge, also during the warranty

8. INSTALLATION

WARNING!
Refer to Safety chapters.

8.1 Before the installation

Before you install the hob, write down the
information bellow from the rating plate.
The rating plate is on the bottom of the
hob.
Serial number ...........................

8.2 Built-in hobs

Only use the built-in hobs after you
assemble the hob into correct built-in
units and work surfaces that align to the
standards.

8.3 Connection cable

• The hob is supplied with a connection
cable.
8.5 Assembly
min.
500mm
min.
50mm
min.
2mm
period. The instructions about the
Service Centre and conditions of
guarantee are in the guarantee booklet.
• To replace the damaged mains cable
use the following (or higher) mains
cable type: H05V2V2-F T min 90°C.
Speak to your local Service Centre.

8.4 Attaching the seal

1. Clean the worktop around the cut out
area.
2. Attach the supplied seal stripe to the
lower edge of the hob along the outer
edge of the glass ceramic. Do not
extend it. Make sure that the ends of
the seal stripe are located in the
middle of one side of the hob.
3. Add some mm when you cut the seal
stripe to the length.
4. Push the two ends of seal stripe
together.