Length Units; Index Of Refraction (Ior) Configuration - Textron GREENLEE 920XC-13A Manual Del Usuario

All manuals and user guides at all-guides.com
Basic OTDR Information

Length Units

Under the parameter configuration menu use p.and.q to highlight "Length Units." Press Enter.
to select the desired units of measurement (Figure 3-16). Press .to.exit.
Figure 3-16. Length Units

Index of Refraction (IOR) Configuration

Because IOR is a key factor affecting the speed of laser transmission in optical fiber, the IOR
configuration has a direct impact on the accuracy of measurement. In general, the IOR parameter
is provided by the optical fiber manufacturer, and it can be set to the accuracy of four digits after
the.decimal.point.between.1.0.and.2.0.
Under the parameter configuration menu use p.and.q to highlight "IOR." Press Enter.to.enter.a.
value (Figure 3-17). Press .to.exit.
Figure 3-17. IOR Configuration
Use.t.and.u to adjust the position of the highlighted area. Use p.and.q.to.change.the.digits..
After.setting,.press.Enter to confirm.
25
920XC-13A • 920XC-15A • 920XC-20C Instruction Manual