Installing Wire Spool And Adjusting Hub Tension; Installing The Wire Into The Welding Gun - Air Liquide M 132 Instrucciones Uso Y Mantenimiento

3.5 INSTALLING WIRE SPOOL AND
ADJUSTING HUB TENSION
1. Install the wire spool (See figure 2)
2. To increase tension, adjust the 11/16" nut in a
clockwise direction.
3. To decrease tension, adjust the 11/16" nut in a
counter clockwise direction.
3.6 INSTALLING THE WIRE INTO THE
WELDING GUN
1. Open the pressure assembly on the wire feeder.
2. Push wire through guide into gun.
3. Close and tighten pressure assembly.
4. Remove gun nozzle and contact tip.
5. Press the gun trigger until wire comes out of
the welding gun.
Typical Weld Parameter Settings: M 132
Typical Weld Parameter Settings: M 172
10
Fig. 2
6. Reinstall contact tip and nozzle.
7. Feed wire by pressing the gun trigger to check
drive roll pressure.
8. Tighten pressure assembly knob enough to pre-
vent slippage.
9. Cut off wire and begin welding.