Installing Sg 185 Spool Gun - Air Liquide M 132 Instrucciones Uso Y Mantenimiento

3.7 INSTALLING SG 185 SPOOL GUN

1. Lift and position the side panel into an upright position.
2. Remove gun inlet cover located on the front panel of the welding machine.
3. Insert the SG 185 Spool Gun through the gun inlet.
4. Remove the gas hose from the gas inlet on the wire feeder unit (See reference 1 in figure 1).
5. Connect the male gas connection (See reference 2 in figure 2) of the spool gun to the gas hose.
6. Remove the male trigger connector (See reference 2 in figure 1).
7. Connect the male spool gun trigger connector (See reference 1 in figure 2) to the female trigger receptacle.
8. Connect the power cable lug (See reference 3 in figure 2) to the positive receptacle inside the unit
(See reference 3 in figure 1).
Fig. 1
1
3
2
Fig. 2
3
1
2
11