The Device Will Operate As Follows During The "Run" Status; Chamber Display Operate As Follows; Display Of The Temperature Detected By The Needle Probe; Display The Evaporator Temperature - Apach ASH05K Manual Del Usuario

•
Press and release the BLAST CHILLING key or do not operate for 15 s: the display will show
"rtc" again and the
Operate as follows to exit the procedure:
•
Do not operate for 60 s.

8.3 THE DEVICE WILL OPERATE AS FOLLOWS DURING THE "RUN" STATUS

•
If a temperature-controlled blast chilling or deep-freezing operation is in progress, the display
will show the temperature detected by the needle probe.
•
If a time-controlled blast chilling or deep-freezing operation is in progress, the display will
show the residual duration time.
•
If storage is in progress, the display will show the cabinet temperature.

8.4 CHAMBER DISPLAY OPERATE AS FOLLOWS

•
Make sure that the keyboard is not locked and that no procedure is in progress.
•
Hold the DOWN key for 1 s: the display will show the first label available.
•
Press and release the UP or DOWN key to select "Pb1".
•
Press and release the BLAST CHILLING key: the display will show the chamber temperature.
Operate as follows to exit the procedure:
•
Press and release the BLAST CHILLING key or do not operate for 15 s: the display will show
"Pb1" again.
•
Do not operate for 60 s.

8.5 DISPLAY OF THE TEMPERATURE DETECTED BY THE NEEDLE PROBE

Operate as follows:
•
Make sure that the keyboard is not locked and that no procedure is in progress.
•
Hold the DOWN key for 1 s: the display will show the first label available.
•
Press and release the UP or DOWN key to select "Pb2".
•
Press and release the BLAST CHILLING key: the display will show the temperature detected
by the needle probe.
Operate as follows to exit the procedure
•
Press and release the BLAST CHILLING key or do not operate for 15 s: the display will show
"Pb2" again.
•
Do not operate for 60 s.

8.6 DISPLAY THE EVAPORATOR TEMPERATURE

Operate as follows:
•
Make sure that the keyboard is not locked and that no procedure is in progress.
•
Hold the DOWN key for 1 s: the display will show the first label available.
•
Press and release the UP or DOWN key to select "Pb3".
•
Press and release the BLAST CHILLING key: the display will show the evaporator
temperature.
Operate as follows to exit the procedure:
•
Press and release the BLAST CHILLING key or do not operate for 15 s: the display will show
"Pb3" again.
•
Do not operate for 60 s.
LED will switch off.
11
Blast Chillers
50LIB055