General Conditions Of Use - neofeu NM16NS Guia De Inicio Rapido

function of another component and that they don't interfere with each other. Verify by visual
examination, before, during, and after use, the proper functioning of equipment and the
absence of defects: condition of the body, axis, and rings... Look for the absence of abnormal
wear, cracks, incipient breaks, distortion and traces of oxidation... and ensure legibility of
markings, (identification and/or date of validity). Verify the proper functioning of the clasps that
should return automatically to their closed position.
Certain connectors are equipped with a fall indicator, verify the presence of this indicator. When
the equipment has been used to arrest a fall, or that some doubt appears as to its reliability,
remove it from circulation and don't use it before getting written authorization from a person
who is competent to decide on its reuse. The fall arrest system must be connected to the dorsal
D-ring of the harness, or to the extremity of the extender strap, if it is equipped with one, or to
two sternal rings simultaneously. These points are identified by the letter A (single fastener) or
A/2 (these two points must be connected together).

4. GENERAL CONDITIONS OF USE :

- Periodical checks must be carried out by a competent inspector to ensure the safety of the
user, who must maintain the efficiency and strength of the equipment. A compulsory annual
check will confirm the condition of the equipment, which may only be kept in service if written
agreement is given.
- These products must be protected against environmental stresses: mechanical (impacts, sharp
edges, etc.), chemical (splashes of acids, bases, solvents, etc.), electrical (short-circuits, arcing,
etc.) or thermal (hot surfaces, blow torches, etc.).
- Do not expose these products to temperatures of below –30°C or above +50°C.
- This equipment may only be used for its specified purpose and it must not, under any
circumstances, be pushed past its limits.
- Storage: the product must be stored in a dry and ventilated place, protected from direct or
indirect heat source and ultraviolet radiation. Wet equipment must be dried under the same
conditions.
- Cleaning and disinfection: only using water with a neutral soap.
- Packaging: use rot-proof and waterproof protective packaging.
- Transport: packaged and protected from impacts or pressures caused by the environment.
- The product may not be modified or repaired in any way.
- Life: the fall arrest IPE made by Néofeu has been designed to work for many years under
normal conditions of use and storage. Its length of life depends on what use it is subjected
to. Certain particularly aggressive, marine, siliceous or chemical environments may reduce
the life of IPE. In such cases, particular attention should be given to its protection and checks
before use. The compulsory annual check will confirm the correct operation of the mechanism
and its continued service; it may only continue to be used with the written agreement of the
manufacturer or its representative. Bearing in mind the above, the approximate life of the
products recommended by Néofeu is ten years. - Keep the identification data and maintenance
follow-up table up to date from the time of commissioning and at each check.
5. LABELING OF THE PRODUCT
- Reference to the connector
- Static load capacity along the main axis: ↔... kN
- Symbol CE and reference No. for the agency notified that is concerned with inspection of this
personal protective equipment.
- Symbol showing that the method of instructions for use must be complied with:
- Norm and Class: EN 362: Year / Class
- Identification of the manufacturer
- Production Lot No.
- Year of manufacture
6. THIS PRODUCT IS COMPLIANT WITH REGULATION 2016/425. IT MEETS
THE REQUIREMENTS OF HARMONIZED STANDARD EN362:2004. THE
DECLARATION OF CONFORMITY IS AVAILABLE AT : WWW.NEOFEU.COM