GYS COMBIDUCTION AUTO 50 LG Manual De Instrucciones página 24

Operating manual
EMC CLASSIFICATION
• This equipment is intended for use in industrial environments (Class A or Group 2) and is not
intended for use in a residential setting where power is supplied from the public, low-voltage supply
network. Ensuring electromagnetic compatibilty may be difficult at these sites due to conducted, as
well as radiated, radio frequency interference.
• This equipment complies with standard IEC 61000-3-12.
• This equipment complies with standard IEC 61000-3-11.
MAINTENANCE / RECOMMENDATIONS
• Maintenance should only be carried out by a qualified person. Annual maintenance is recommended.
• Warning! Always disconnect from the mains before carrying out maintenance on this machine. Vol-
tages and currents are high and dangerous inside the machine.
• Remove the cover and blow out the dust. Take the opportunity to have the earthing and electrical
connections checked with an insulated tool.
• Do not use solvents or any agressive cleaning products.
• Clean the device's surfaces with a dry cloth.
• If the power cable or lance is damaged, it must be replaced by the manufacturer, the service depart-
ment or a similarly qualified person in order to avoid a safety hazard.
• If the internal fuse has blown, it must be replaced by the manufacturer, the service department or a
similarly qualified person in order to avoid a safety hazard.
• Do not block the vents. Refer to the installation instructions before using the appliance.
• Keep at least 50 cm of free space around the equipment.
TRANSPORT
• Do not use the power cable or lance to move the unit. It should be moved in an upright position.
• The handles are not designed to be used to lift the device.
RULES AND REGULATIONS
• This device complies with European directives.
• The declaration of conformity is available on our website (see cover page).
• This equipment conforms to UK requirements.
• The UK Declaration of Conformity is also available on our website (see cover page).
• This device complies with Moroccan standards.
• The C‫( م‬CMIM) declaration of conformity is available on our website.
• The Eurasian Economic Community (EAEC) mark of conformity.
WASTE DISPOSAL
• This equipment is subject to selective collection. Do not dispose of in domestic waste.
• This is a recyclable product that is subject to recycling instructions.
PRODUCT IDENTIFICATION
The machine's CE marking can be found on the back of the product on an identification plate, along with the following:
• Manufacturer's name and address
• Manufacturing date
• Model
• Product type
• Operating voltage
This data must be given every time a technician is called in or if spare parts are needed.
24
Translation of the original
instructions
COMBIDUCTION AUTO 50 LG