"Timer" Mode - GYS COMBIDUCTION AUTO 50 LG Manual De Instrucciones

Operating manual
NB: In the event of an alarm, the appliance will not heat up.
The device is equipped with several electronic protection systems for electrical overload and cooling. The inductor's thermal
protection is particularly important when heating stainless steel, copper or aluminium parts. To restart, simply wait for
the cooling process to end. For all other protections, switch the device off and on again using the main switch.
For E-6 and E-7 alarms, please check:
- if there is a possible leak.
- that the hose is not blocked or kinked.
- that the pump is not blocked or defective.
- there is enough coolant.
If the fault appears to be rectified, press the inductor change button (11) twice. The product will perform a purge cycle.
It is now ready for use.

"TIMER" MODE*

The "Timer" function allows you to control the COMBIDUCTION's heating time.
The time can be adjusted from 1 to 30 seconds.
To enter this mode:
1. Press the main power button (2). Its indicator light will come on.
2. Then, press both power-setting buttons (5) simultaneously.
3. The display will show "SEC" then "T 00" or "SEC", then "ON" if a time has already been set.
4. The power-setting buttons (5) become time-setting buttons. Change the time settings as required.
If, after three seconds, the time value has not been changed and still shows "T 00", the COMBIDUCTION will return
to normal mode.
Using the "Timer" mode:
Once the time settings have been selected, the product is ready for use. The LED light (13) is on.
1. Press the lance button (12). The intensity of the LED indicator light (13) will decrease signalling that the machine is
actively heating up.
2. The heating will stop when the time is finished. As long as the lance button (12) is pressed, the LED indicator light (13)
and the main power button (2) will flash to advise that the power is switched off. Adjust the time settings if necessary.
3. Press the lance button (12) to start a new heating cycle.
Leaving "Timer" mode
This mode always remains active, even when the COMBIDUCTION is switched off and on again.
1. To exit this mode, set the time settings to ∞ or press the two power control buttons (5) simultaneously. The COMBI-
DUCTION will return to its normal operating mode. The display will read "SEC" and then "OFF".
This mode's special-feature power settings.
As explained, in normal use the control buttons are used to alter the power, whereas in this mode they are used to alter
the time settings. How to change the power without leaving this mode:
1. Press the main power button (2). Its green indicator light will go out.
2. The setting buttons (5) are used to change the power. Adjusting the power.
3. Press the main power button (2) again. Its indicator light will come back on. The setting buttons (5) will revert to con-
trolling the time settings.
"ACCESSORY-CHANGE" MODE
1
STOP
This function can only be used if the heating process is not activated (green button off).
Translation of the original
instructions
3 4
A B
screen-printed product
COMBIDUCTION AUTO 50 LG
5
OK
Max. tightening torque = 7 Nm
29