Automatic Mode - GYS COMBIDUCTION AUTO 50 LG Manual De Instrucciones

Operating manual
Putting the heater on standby mode
For safety reasons, the product disables all heating power after the power source has been inactive for five minutes. The
green LED indicator light on the main power button (2) and the LED indicator light on the lance holder (13) will go out.
To restart the power source, press and hold the start button (12) for one second.
After being inactive for 20 minutes, the power source can only be reactivated by pushing the main power button (2).
Heating with bodywork
inductors
Connecting attachments and accessories
1. Select the desired inductor.
2. Lift the lid to reach the COMBIDUCTION socket.
3. Plug the inductor connector into the COMBIDUCTION.
4. Close the lid to secure the connection.
5. The display screen will show the number of connected accessories (e.g. AC1)
Heat activation
Press the main power button (2)
All inductors can be operated using the foot pedal. Glass, dent-removal and spiral inductors are also fitted with a heating
button.
Bring the inductor close to the metal part that is to be heated, then press the inductor button or foot pedal to activate the
heating process.
The power source will detect this and start up in automatic mode.

Automatic Mode

To access this mode:
Manual Mode
To access this mode:
How it works:
Manual mode allows the COMBIDUCTION to reach its maximum power. At this power level, work-
pieces can be heated very quickly. The closer the inductor is to the workpiece, the greater the heating
power.
Audible heating signals
To activate / deactivate
Translation of the original
instructions
In this mode, the COMBIDUCTION adapts to the workpiece it is heating
(size-thickness) and also to the distance between the workpiece and the
inductor. It maintains a constant and optimal heating power. The heater will
never heat up to full power in this mode.
Automatic mode is the default mode. However, if the machine is in Manual
mode, press the inductor-change button (11) briefly until the dashes on the
digital display (6) flash.
Display:
The digital display shows the last % value used by the machine to maintain
a constant, optimal output according to the heating requirements. This value
corresponds to the settings that would have to be used in Manual mode to
obtain the same result under the same conditions. Therefore, if the user
considers the heating recommended by the COMBIDUCTION to be too
low or too high, the user can set this value in manual mode and adjust it as
desired to reach the required power.
In this mode, the user selects the desired heating power themsevles.
Press the change-inductor button (11) briefly until a numerical value is dis-
played.
The digital display screen (6) indicates the maximum power percentage
(2,400 W) that the inductor can transmit to the workpiece to be heated. Use
the adjustment dials (5) to change the desired power level.
A beeping sound can be switched on to indicate heating activity. The beep
sounds as soon as the heating process is active and its frequency varies
according to the position of the inductor in relation to the workpiece to be
heated. The closer the inductor, the higher the frequency.
Press the change-inductor button (11) for three seconds to activate/deacti-
this feature:
vate this sound.
COMBIDUCTION AUTO 50 LG
27