Fault Correction; Connecting The Foot Pedal - GYS COMBIDUCTION AUTO 50 LG Manual De Instrucciones

Operating manual
8. Tighten the inductor with a maximum torque of 7 Nm.
9. Press the inductor change button (11) twice. The purge cycle takes five seconds and is indicated by a loading sign
shown on the display screen. A double beep indicates the end of the cycle.
10. The display screen will alternate between the coolant temperature and the power setpoint.
11. Top up the coolant if necessary.
12. Put the supplied tank cap in the accessory case. The product is ready for use.
E-7 fault correction
After five unsuccessful attempts at completing a purge cycle, the following procedure is to be undertaken:
- Stretch out the lance over the product, so that the water pockets drain away allowing the pump to prime.
- Tilt the product approximately 30° towards the lance.
- It is now possible to blow into the end of the lance. Use a compressed-air blower with a cloth to seal the end of the lance
and avoid splattering.
- Restart one or two cycles after each action.
If the problem persists, then check that the pump is working properly or that the pipe is not pinched or blocked.
INSTRUCTIONS FOR USE

Connecting the foot pedal

The COMBIDUCTION is supplied with a foot pedal (ref. 055490), which is very practical and even necessary for the
use of some inductors (adhesive inductors). Connect the hose to the COMBIDUCTION and to the foot pedal to make
it operational.
1. Flip the main switch (1) to the ON position.
The machine carries out its start-up phase for two seconds.
This product has two heating options: the first using the lance or the second using the bodywork inductors.
It always starts up when the power is turned on and heats up through the lance.
Lance heating
2. Press the main power button (2). The indicator light for button two and the LED indicator light for the inductor (13) will
light up, signalling that the product is ready for heating.
3. Position the inductor (16) flat on the workpiece or the part to be heated (place the open part of the ferrite against the work-
piece).
4. Press button (12) on the lance or on the foot pedal (18) to start heating; if necessary move the inductor to heat a
larger area. Two indicator lights show that the heater is active:
- The brightness of the inductor's LED indicator light (13) will decrease*.
- The minimum-power indicator light on the heating power indicator (4) will flash rapidly (in HI mode both minimum
and maximum indicator lights will flash).
It is possible to change the power setpoint while heating.
The heating setpoint can be set to the value Hi. The power is the same as the 100% mode but the COMBI-
DUCTION will behave differently:
- At 100%: it turns the workpiece red and keeps it at the right power for a few seconds before slowly
achieving its maximum power.
- In Hi mode: it will climb to its maximum power regardless of the condition of the workpiece to be heated.
Be very careful, the heating process is strong, fast and may damage the workpiece.
The display continuously shows the coolant temperature (max. 60°C/140°F).
- During the initialisation phase, the cooling system's pump and fan will run for a few seconds to check that it is working
properly.
- After stopping the heating process, allow the cooling system to fully cool the inductor before switching off the product.
- To change the unit used to display the coolant's temperature, press and hold both setting buttons (5) until the desired
unit is selected («-F-» = Fahrenheit / «-C-» = Celsius). When you release the buttons, this change is saved and dis-
played.
The machine has been designed to minimise the risks caused by electromagnetic fields. There are still
risks and it is recommended that a minimum safety distance of 30 cm is kept between the inductor and the
operator's head or torso.
26
Translation of the original
instructions
COMBIDUCTION AUTO 50 LG