Pre-Operation; Check Battery; To Roll Tractor Off Skid; To Drive Tractor Off Skid - TRAPP 42L13G60x8A Manual De Instrucciones

Check battery

Raise seat pan to highest position.
Note: Should the battery be first used after
the month and year stated on the label
(located between the terminals), charge it for
at least one hour at 6 - 10 A (see "Battery"
in the Maintenance section of this Manual, to
check load instructions.
Note: The tractor may now be pushed or
driven out of the base. Follow the
instructions below before removing the
tractor from the base.
Warning!
Before starting, read, understand and
follow all the instructions in the
Operation section of the manual. Be
sure tractor the tractor is in a well-
ventilated area. Be sure the area in
front of the tractor is clear of people
or objects.
All manuals and user guides at all-guides.com

Pre-operation

To roll tractor off skid

(see Operation section for location and
function of controls)
1. Press lift lever plunger and raise attachment
2. Release parking brake by depressing
3 Place motion control lever in neutral (N)
4 Roll tractor forward off skid.
5. Remove banding holding deflector shield up

To drive tractor off skid

(see Operation section for location and
function of controls)
1. Check engine oil level and fill fuel tank with
2. Sit on seat in operating position, depress
3. Place motion control lever in neutral (N)
4. Press lift lever plunger and raise attachment
5. Remove key from packing and start the
6. Depress clutch/brake pedal to "Brake"
7. Slowly release clutch/brake pedal and drive
lift lever to its highest position.
clutch/brake pedal.
position.
against tractor.
gasoline.
clutch/brake pedal and set the parking
brake.
position.
lift lever to its highest position.
engine (see "To start the engine", in the
Operation section of this Manual). With
engine running, move throttle control to
slow position.
position and hold it. Move motion control
lever to first gear.
tractor off skid.
89