How To Use Your Tractor; To Set Parking Brake; To Stop Mower Blades; To Stop The Tractor - TRAPP 42L13G60x8A Manual De Instrucciones

The operation of any tractor can result in foreign objects thrown into the eyes
Wear your
of the operator, which can result in severe eye damage. Always wear safety
Safety glasses
glasses or eye shields while operating your tractor or performing any
adjustments or repairs. We recommend a wide vision safety mask over
Foresight is better
spectacles or standard safety glasses.
than no sight

How to use your tractor

To set parking brake

Your tractor is equipped with an operator
presence sensing switch. When engine is
running, any attempt by the operator to leave
the seat without first setting the parking
brake will shut off the engine.
1. Depress clutch/brake pedal fully and hold.
2 Place parking brake lever upward and
release clutch/brake pedal. Pedal should
remain in brake position. Make sure parking
brake will hold tractor secure.

To stop mower blades

✔
To stop mower blades, move attachment
clutch switch to disengaged position.
All manuals and user guides at all-guides.com

To stop the tractor

✔
✔

To stop the engine

✔
✔
✔
Fully depress the clutch/brake pedal.
Move motion control lever to neutral (N)
position.
Place the throttle control between
medium and fast speed positions.
Note: Failure to move the throttle
control between medium and fast
speed position before stopping the
engine, may cause engine to "backfire".
Turn the ignition key to "STOP" and
remove it. Always remove key when
leaving tractor to prevent unauthorized
use.
Never use choke (N) to stop the engine.
Important: Leaving the ignition key in
any position other than "STOP", will
cause the battery to be discharged.
Note: Under certain conditions when
tractor is standing idle with the engine
running, hot engine exhaust gases may
cause "browning" of grass. To eliminate
this possibility, always stop engine
when stopping tractor on grass areas.
Caution!
Always stop tractor completely as
described above, and set parking
brake before leaving the operator's
position.
93