Cleaning And Maintenance; Spare Parts - Renfert hotty LED Instrucciones De Servicio

5.1 Setting the Temperature
scale to °C or °F
Please observe that all 230 V
units are pre-set to centigrade
(°C) and that all 120 V units are
pre-set to Fahrenheit (°F).
1. Steps 1 - 4 (point 5) must be fulfilled
before doing this.
2. Press and hold buttons ‑ and + (fig. 6)
and turn on the hotty LED by pressing
the button (A).
3. The LED-Display (D) now shows
C = degrees Celsius (fig. 7) or
F = degrees Fahrenheit (fig. 8).
4. After 5 seconds, the display changes
between C and F or vice versa, then
release buttons ‑ / +. Following this,
you will see the nominal temperature
displayed shortly, then the actual tem-
perature.
5.2 Setting the nominal
temperature
To set the temperature, press buttons ‑/+
(E) repeatedly until the required value
is displayed (fig. 9). This value is saved
automatically after 5 seconds even after
the unit is switched off.
Notice:
The nominal temperature is
saved automatically within
5 seconds. After that the hotty
LED can be turned off using the
button (A) or the mains supply.
All values will be saved.
5.3 Dipping
(fig. 10)
• Support the hand well.
• Dip your object quickly into the wax, past
the preparation margin.
• Pull the object back out in a slow move-
ment.
• Hold shortly before the tip of the die
leaves the wax pot, allowing excess wax
to drip off.
6. Cleaning and
Maintenance
The hotty LED is maintenance free. Wipe
off the surface from time to time using a
damp soft cloth.
Never use detergents or solvents!
Never rinse the hotty LED with
running water!
Cold wax remnants can be removed by
carefully scraping them off.
Lightly warming the surface with a hairdry-
er makes it easier to remove any unwant-
ed wax.

7. Spare Parts

You can find components subject to wear
and the spare parts on the spare part list
in the internet at www.renfert.com/p918.
The components excluded from the
warranty (such as consumables or parts
subject to wear and tear) are marked on
the spare part list.
Serial number and date of manufacturing
are shown on the type plate of the unit.
8. Guarantee
Under proper use, Renfert warrants the
hotty LED for a period of 3 years. Con-
ditions for the fulfilment of this warranty
include the presentation of original buyers
receipt from a recognised dealer. Parts
which are subject to natural wear and
tear (wear parts) and consumables are
excluded from the guarantee. These parts
are marked in the spare part list.
Warranty becomes void in a case of
improper use, failure to observe operating,
cleaning, maintenance and connection
instructions. Also in the case of inde-
pendent repairs or repairs carried out by
unauthorised personnel, or if unauthorised
spare parts are used and when influenc-
es unusual or in noncompliance with the
instructions for use apply. Services carried
out under warranty do not extend the
warranty period.
- 3 - EN