Cleaning & Maintenance; Disposal Information - Renfert SILENT EC2 Guia De Inicio Rapido

Cleaning / Maintenance
The device does not contain any parts that require maintenance.
Opening the device other than described in the instructions is not permitted!
EN
Cleaning
To clean the device wipe only with a damp cloth.
Do not use and solvent-based or abrasive cleaning agents.
Empty Dust Drawer
After reaching the set time interval, the dust drawer is requested to be emptied:
♦ An acoustic signal sounds 3 x.
♦ The symbol "dust drawer full" is shown.
♦ In the display "FULL" is shown.
Before removing the dust drawer, a filter cleaning function should be performed:
⇒ Press Enter key (30) for 2 seconds.
♦ The filter cleaning function is performed (duration approx. 8 seconds).
After the filter cleaning has finished:
⇒ Unlock the dust drawer with the clamp fastener (4A).
⇒ Pull the dust drawer (4) forward and empty.
⇒ Replace the dust drawer again until it locks into place.
⇒ Close the clamp fastener (4A).
⇒ Press the Enter key (30) (counter for recording the time interval is reset).
♦ Acoustic signal acknowledges the information.
♦ Dust drawer display (23) is deleted.
If the dust drawer is not emptied, the "Dust drawer full" and "FULL" symbols are still shown in the
display. After switching the device off and on again, a 3 x acoustic signal is used to indicate the
emptying of the dust drawer.
To set the time interval, see Fig. D at the start of this manual, or find information in the instructions for use
in the Internet.
Change fine filter
If the filter cleaning does is not sufficient (suction performance does not improve), then the fine filter
needs to be changed.
This is detected by the suction system and indicated by "FILt" in the display.
When installing the fine filter, pay attention to the correct fit, otherwise there will be leakage. Please refer
to the assembly guide at the end of this manual, which is also included with the new fine filter.
Spare Parts
You can find components subject to wear and the spare parts on the spare part list
in the internet at www.renfert.com/p918.
Enter the following item number: EC2: 29370000, TC2: 29360000.
The components excluded from the warranty (such as consumables or parts subject
to wear and tear) are marked on the spare part list.

Disposal Information

Within the European Union, units with this symbol should not therefore be disposed of in unsort-
ed domestic waste.
Please contact your local authorities for more information on proper disposal.
- 6 -
Subject to change