Cleaning And Maintenance; Spare Parts - Renfert Vario E Instrucciones De Servicio

The setpoint temperatures in
the individual pots, together
with the most recently selected
pot are stored in memory even
if the power is switched off or in
case of a power failure, provid-
ed the most recent change to a
setpoint temperature was made
at least 4 sec. prior to the power
outage.
When the unit is again switched
on or power is restored, the
Vario E returns to the previously
saved operating state.
Notes / Tips on Operation:
• Opaque waxes may separate
while heating in the Vario E.
Before beginning work, use an
instrument to stir these types
ofwaxes.
• Wax can be most easily removed
shortly after the unit is switched
on. Once the wax has begun to
melt around the edges, the wax
cylinder can simply be removed.
• When carving the edges of
crowns, the pot rims on the
Vario E are ideally suited to warm
the instrument (this prevents the
instrument from becoming exces-
sively hot, as can occur when
an open flame is used). Within
seconds, the instrument will be
warm to the touch; the ideal tem-
perature for working on the wax
crown edge.
• Quickly withdrawing the instru-
ment from the Vario E = Larger
wax beads; Slowly withdrawing
the instrument from the Vario E =
Smaller wax beads.
• To speed the melting process,
always close the lid on the wax
pot during the melting phase.
EN
• If the wax liquefied in the Vario E
is processed with Waxlectric mod-
elling instruments, the processing
temperature of the electric wax
knife can be significantly reduced,
since the knife no longer needs
to supply the energy required to
melt the wax.
Tips on Dipping:
• Do a quick dip to just beyond the
preparation border.
• Slowly and evenly remove the die
from the wax.
• Just before the tip comes out,
hold it steady in the pot for a short
time so that any excess wax can
drop down.

6. Cleaning and Maintenance

The Vario E is maintenance free. From
time-to-time, you should wipe your unit
down with a damp cloth.Never use deter-
gents or solvents!
Never rinse or spray your Vario
E directly with water.
With the unit switched off, you can remove
hardened wax residue by carefully
scraping it.
Warming the unit's surfaces with a hair
drier will make it easier to remove wax
residue.
The lid of your Vario E can be removed for
gently cleaning with the steam jet.

7. Spare Parts

You can find components subject to wear
and the spare parts on the spare part list
in the internet at www.renfert.com/p918.
The components excluded from the
warranty (such as consumables or parts
subject to wear and tear) are marked on
the spare part list.
Serial number and date of manufacturing
are shown on the type plate of the unit.
- 4 -