5�5�3 Suction Turbine After-Run Time; Cleaning / Maintenance; Cleaning & Maintenance; 6�2 Empty Dust Drawer - Renfert SILENT powerCAM EC Traducción Del Manual De Instrucciones Original

5.5.3 Suction turbine after-run time
After-run time = The period of time between the OFF command in the CAM system and moment the suc-
tion turbine actually stops functioning�
EN
It is possible to select between 6 different times�
After-run time / Secs.
To change:
⇒ Press operating mode key (21) for 3 sec�
LED2 LED3 LED4
♦ Start the programming mode�
⇒ Press operating mode key (21) again 3 x�
♦ flashes
LED2 LED3 LED4
⇒ Press enter key (25)
♦ Select the after-run time�
T3 T4
A blink signal is emitted according to the set after-run time�
♦
⇒ Change the after-runt time using the extraction force key (23)�
Each key press selects the next higher time� After 30 secs� it is possible to select 0 secs again�
T3 T4
⇒ Press enter key (25)
♦ Save input, exit the programming mode�
In order to prevent the suction unit from switching on/off too frequently in the event of short inter-
ruptions, it is advisable to select a higher time.
6

Cleaning / Maintenance

Inside the appliance there are no parts which require maintenance.
Opening the device, other than for the processes described below, is not permissible!
6.1 Cleaning
Use a damp cloth to clean the outside of the unit�
Do not use abrasive or solvent-based cleaning agents�
6.2 Empty Dust Drawer
After having reached the previously set time interval (see chap-
ter� 5�5�1) a request appears to empty the dust drawer�
♦ An audible signal will be emitted 3 x�
♦ The display dust drawer (24, Fig� 2) lights up�
Before removing the dust drawer, a filter cleaning procedure
should be carried out�
⇒ Press the enter key (25) for 2 seconds�
♦ The filter cleaning procedure is carried out (duration approx.
8 seconds)�
After the filter cleaning has finished:
⇒ Unfasten the dust drawer (4A)�
⇒ Pull the dust drawer forwards (4)�
⇒ Remove the holder (14, Fig� 1)�
⇒ Close the waste bag, remove and dispose of�
Observe the local waste regulation and accident prevention regulations when disposing of the
product! Wear the appropriate personal protection equipment according to the type of dust.
LED1
Blink signal in the display
0
3
5
10
20
30
T1a/T1b
T1a/T1b
LED2 LED3 LED4
1x
T2 2x
T3 T4
3x
4x
5x
6x
- 12 -
T1a/T1b
factory setting
21 23
4A
4
25
Fig. 11
Fig. 12