Recycling Instructions - EdmoLift AL Manual De Productos

EdmoLift Products Manual
Lift Trolleys
3
EdmoLift's WP Work Positioner and TZ/EZ Lift Trolleys are intended for use as worktables, for convenient and
efficient movement, with or without load, between various work positions indoors, under normal industrial and
storage conditions of temperature, humidity, and lighting. Typical applications are tool changing, assembling, service
and repair of machinery and control cabinets, feeding and stacking of components at processing machines and within
storage areas. When moving between different working areas the load must always be in the lowered position.
Appropriate usage and loading information is detailed in this manual and can be found in EN 1757-pt.1.
Armlifts, Pallet lifts and Tilts
4
EdmoLift's armlifts, pallet lifts and tilts can be used for a wide range of applications. The Armlifts are basically intended
for lifting, lowering and tilting of loads which are uniformly distributed over the entire platform area, e.g. on Europallets,
2-way entry pallets or totebins. The Tilts are intended to be used for tilting. Typical applications for armlifts, pallet lífts
and tilts are stacking of components for processing machines, assembly of electrical cabinets, handling parts for the
automotive industry etc.
These products provide the opportunity to tilt the platform, and also the load. Together with increased productivity, the
task is simplified and provides improved ergonomics for the operators. Tilting creates a risk of the load carrier (pallet,
container, totebin etc) and load falling off which can cause injury to any personnel in the area, or damage to the
material. It is therefore very important that the armlift/pallet lift/tilt be positioned so that no personnel could be injured
when tilting is in progress. It is essential that the tilting be performed in such a manner that the load carrier is secure
and also to use a load carrier that is suitable for the load being handled. A common accessory is a load restraint to
prevent the load from sliding off the platform when tilted.
Armlifts, pallet lifts and tilts are intended to be operated on a flat, firm base or floor. The floor must be strong enough
to support the armlift/pallet lift/tilt, and load. It is recommended that armlifts and tilts intended for static operation be
fixed to the floor, to avoid accidental movement if struck by a truck or similar. The intended application and loading
conditions are relevant to the "CE Declaration of Conformity" document.

Recycling instructions

5
Our Lift Tables are manufactured from re-usable materials or from materials that can be recycled. Specialized
companies will take care of worn out Lift Tables, dismantle them and utilise materials where appropriate.
Copyright © EdmoLift AB 2004-2007
All rights reserved. No part of this publication may be reproduced, stored in a retrie-
18
val system, or transmitted in any form or by any means, electronic, mechanical,
photocopying, recording or otherwise without the permission of the publisher.
2006-05-15
EdmoLift AB
Jägaregatan 11
S-871 42 HÄRNÖSAND, SWEDEN
85921 GB
Tfn. +46 (0)611-83 780
Fax. +46 (0)611-51 15 80
info@edmolift.se