EdmoLift AL Manual De Productos página 188

EdmoLift Products Manual
Bolting down the Lift Table
Static double and triple vertical lift tables and other tables with high stroke must be affixed to the floor/ground. We also
recommend that all other static lift tables are securely bolted down to prevent unintentional movement.
Type
TRD 200
TED 400
TRD 400
TRD 500
TLD 1000
TLD 2000
TMD 1500
TMD 3000
TSD 1500
TTD 3000
TTD 5000
TPD 4000
TXD 4000
TFD 4000
TMT 1500
TST 2000
Installation of lift table on the floor/ground or in a pit.
Static double and triple vertical scissor tables must be fixed to the floor/ground by means of expander bolts or similar.
We also recommend that all other lift table types, with the exception of mobile units, are securely affixed to the floor to
prevent unintentional movement.
Mechanical/electrical installation
1. The base frame of the lift table is not as standard self supporting. It is important that the flooring is flat and stable
and that the installation area or pit, if necessary, is well drained.
2. Raise the lift and engage the service supports. See picture on page 39.
3. Utilise a lifting sling through the scissor package. Tie the base frame to the platform or the scissor mechanism.
Locate the table into the desired position. Turn the fixed arm end to the side where the load will be moved on or off at
upper level. See picture below.
4. Operate the table and test all functions. Adjust the lowering speed if necessary. Do not exceed the maximum
permissible speed with full load. (As standard not faster than 0,1m/s).
5. Check the operation of the safety frame on all sides. Adjust if necessary.
6. The control device should be positioned so that the operator has a clear view of the lift table and the load at all
times when the lift is operated.
7. Permanently fix the table on the floor/ground with expander bolts or similar. See above proposal for fixing.
Copyright © EdmoLift AB 2004-2007
All rights reserved. No part of this publication may be reproduced, stored in a retrie-
42
val system, or transmitted in any form or by any means, electronic, mechanical,
photocopying, recording or otherwise without the permission of the publisher.
Torque kN Expander Bolt
1.1
2.5
2.5
2.4
4
7
3.7
8.4
2.9
12.2
12.2
5.8
4.6
4.6
3.8
4.7
M6x70
M6x70
M6x70
M6x70
M10x60
M16x100
M10x60
M16x100
M10x60
M20x120
M20x120
M12x75
M12x75
M12x75
M10x60
M12x75
EdmoLift AB
Jägaregatan 11
S-871 42 HÄRNÖSAND, SWEDEN
2005-02-01
Tfn. +46 (0)611-83 780
Fax. +46 (0)611-51 15 80
info@edmolift.se
85921 GB