EdmoLift AL Manual De Productos página 168

EdmoLift Products Manual
Technical data for standard model Pallet Lifter
Note! Maximum load refers to the load being uniformly distributed over the entire platform area.
In accordance with SS-EN 1570 the basic requirements are:
1 / 1
Maximum permitted horizontal force: 10% of the rated load (max. load) taken as acting horizontally at platform
level
Horizontal forces can occur, for example, when pressing on to the lift or the load, or when pulling or pushing a tool or
component on the platform or the pallet. If the horizontal force is applied on th eload tilting moment increases.
It is difficult to measure the impact of a horizontal force, so utmost care must be taken.
If an alternative load distribution has been agreed, refer to the order documentation. Intensive use, high speed,
harsh environment and multi-shift operation may require a HD-package to be fitted, i.e. stronger bearings etc. than
the standard construction, Technical data for each lift is included in the order documentation and the CE Declaration
Conformaty.
Copyright © EdmoLift AB 2004-2007
All rights reserved. No part of this publication may be reproduced, stored in a retrie-
22
val system, or transmitted in any form or by any means, electronic, mechanical,
photocopying, recording or otherwise without the permission of the publisher.
• 100% of the rated load (maximum load) uniformly distributed over the entire
platform area.
• or 50% of the rated load (maximum load) uniformly distributed over half the
length of the platform.
• or 33% of the rated load (maximum load) uniformly distributed over half the width
of the platform.
1 / 2
EdmoLift AB
Jägaregatan 11
S-871 42 HÄRNÖSAND, SWEDEN
85921 GB
2005-02-01
1 / 3
Tfn. +46 (0)611-83 780
Fax. +46 (0)611-51 15 80
info@edmolift.se