EdmoLift AL Manual De Productos página 176

EdmoLift Products Manual
On Delivery
1
Equipment is delivered fully tested. Hydraulic fluid is included. As standard this fluid is hydraulic oil in accordance with
ISO 32. See order specification regarding alternatives.
As standard the electrical system is for connection to 3-phase 400 V, 50 Hz. There is no neutral wire.
The control system (control box, safety frame, solenoid valve, limit switches etc.) operates on 24 V DC. The control
circuit is fed from the electrical box (included), containing transformer, rectifier, motor contactor, printed circuit board,
control circuit fuses and junctions. Additional junctions for limit switches etc. are also included
Lifts are painted in colours:
Blue = RAL 5005 Yellow/orange = RAL 2010
Decals
2
Check regularly that the decals affixed to the Lift at time of delivery remain intact, clearly legible and are in the correct
language.Decals that are damaged or illegible must be replaced.
An "Operator´s Instruction" sign is supplied with the manual. This provides instruction that only authorised persons
may operate the equipment and information about the rated maximum load. On installing the lift, this sign should be
placed adjacent to the control position.
Decals and markings
3
In special cases, decals may be located in other positions. Additional decals may be included for some accessories or
applications.
Place the "operator´s label" at the control position.
Copyright © EdmoLift AB 2004-2007
All rights reserved. No part of this publication may be reproduced, stored in a retrie-
30
val system, or transmitted in any form or by any means, electronic, mechanical,
photocopying, recording or otherwise without the permission of the publisher.
2005-02-01
EdmoLift AB
Jägaregatan 11
S-871 42 HÄRNÖSAND, SWEDEN
85921 GB
Tfn. +46 (0)611-83 780
Fax. +46 (0)611-51 15 80
info@edmolift.se