Porsche 7PP.971.675.AA Manual Del Usuario página 16

Setup
Changing the supply cable
Electric shock
DANGER
Risk of serious or fatal injury from electric shock.
e
Before changing the supply cable, always unplug
the supply cable from the electrical socket and
disconnect the vehicle cable from the vehicle
charge port.
e
Only change cables in a dry environment.
e
Use the control unit with vehicle cable only in
conjunction with a supply cable included in the
scope of delivery or with a supply cable approved
by Porsche.
g Refer to chapter "Scope of supply" on page 8.
e
Depending on country, e.g. in Norway or Japan
it is prohibited to change the supply cable. Fur-
ther information is available from your authorized
Porsche dealer.
− 1. Time of printing. Further information is available from your authorized Porsche dealer.
14
,
1
Fig. 7 Plug of the supply cable connection on the
control unit
The plug of the supply cable connection is released
and plugged in at the upper end of the control unit.
Disconnecting the supply cable
Fig. 8 Disconnecting cables
b Charging of the high-voltage battery has ended
and the vehicle plug has been removed from the
vehicle charge port.
b The plug has been disconnected from the elec-
trical socket.
1. Remove screw (Fig. 8) using a suitable tool.
C
2. Lift the lever (Fig. 8).
A
3. Pull out the plug (Fig. 8) until resistance is first
B
felt.
4. Close the lever .
A
5. Pull out the plug fully.
B