Operation; Operating Instructions - Porsche 7PP.971.675.AA Manual Del Usuario

Securing supply cables and plugs
Fig. 9 Securing cables and plugs
b The lever
(Fig. 9) is closed.
A
1. Insert the plug (Fig. 9) into the control unit
B
until resistance is first felt.
2. Lift the lever .
A
3. Push in the plug fully.
B
4. Close the lever .
A
5. Secure the plug to the control unit using screw
B
(Fig. 9).
C
− 1. Time of printing. Further information is available from your authorized Porsche dealer.

Operation

Operating instructions

NOTICE
Risk of damage to the charger
e
Always place the charger on a solid surface when
charging.
e
Porsche recommends using the charger in the
wall mount. In some countries, e.g. Switzerland
the charger may only be used in the Basic wall
mount.
g Refer to chapter "Installing the wall mount" on
page 9.
e
Do not immerse the charger in water.
e
Protect the charger from snow and ice.
e
Protect the charger against potential damage
through being driven over, dropped, pulled, bent
or crushed.
The charger must only be operated within a temper-
ature range from –22 °F to +122 °F (-30 °C to
+50 °C).
Information
− To prevent overheating during operation, avoid
continuous exposure of the charger to direct
sunlight. If the control unit overheats, charging
is interrupted or the power is reduced automati-
cally until the temperature has returned to the
normal range.
−
When driving abroad, always carry the appropri-
ate supply cable for the country you are visiting
with you.
1 ,
− Different safety concepts are prescribed with
different device variants depending on the coun-
try. Before traveling abroad, make sure that the
charger can also be used in the relevant coun-
try. Further information is available from your
authorized Porsche dealer or the local electricity
supplier.
Operation
15