General Power Tool Safety Warnings; Work Area Safety - Parkside PMFS 200 C3 Manual Del Usuario

Noise and vibration data
Noise measurement value determined in accord-
ance with EN 62841 . The A-rated noise level of
the power tool is typically as follows:
Sound pressure level
Sound power level
Uncertainty
Wear ear muffs!
Rated acceleration, typically
Hand/arm vibration
Uncertainty
NOTE
► The vibration emission values and the noise
emission values given in these instructions
have been measured in accordance with a
standardised test procedure and can be used
for comparison of the power tool with
another tool .
► The specified total vibration values and the
noise emission values can also be used to
make a provisional load estimate .
WARNING!
► Depending on the manner in which the
power tool is being used, and in particular
the kind of workpiece being worked, the
vibration and noise emission values can
deviate from the values given in these instruc-
tions during actual use of the power tool .
► Try to keep the vibration loads as low as
possible . Measures to reduce the vibration
load are, e .g . wearing gloves and limiting the
working time . Wherein all states of operation
must be included (e .g . times when the power
tool is switched off and times where the
power tool is switched on but running without
load) .
PMFS 200 C3
L = 74 .3 dB (A)
PA
L = 85 .3 dB (A)
WA
K = 3 dB
a = 5 .428 m/s
2
h
K = 1 .5 m/s
2
General power tool
safety warnings
WARNING!
► Read all safety warnings, instructions, illus-
trations and specifications provided with
this power tool. Failure to follow all instruc-
tions listed below may result in electric shock,
fire and/or serious injury .
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to
your mains-operated (corded) power tool or
battery-operated (cordless) power tool .

1 . Work area safety

a) Keep work area clean and well lit. Cluttered
or dark areas invite accidents .
b) Do not operate power tools in explosive
atmospheres, such as in the presence of flam-
mable liquids, gases or dust. Power tools create
sparks which may ignite the dust or fumes .
c) Keep children and bystanders away while
operating a power tool. Distractions can cause
you to lose control .
GB │ IE │ 3 ■