Drain Connection; Connecting To A Gas Line - Bartscher M 10110g Manual De Instrucciones

5.1.6 Drain connection

•
At the condensate-collecting tray located in
front of the oven, there is a drain hose (with
an inner diameter of 10 mm). This hose drains
excess liquids from the condensate-collecting
tray away and runs in the rear part below the
device (see A - picture on the right). To drain
the water to the drainage system, extend the
available hose as needed.
•
Fasten the supplied drain pipe to the outlet
hole located under the device to ensure the
outflow of liquids from the cooking
compartment.
The drain pipe must be connected with a suitable
hose (∅ 22 mm) to the drainage system.

5.1.7 Connecting to a gas line

Gas devices must be serviced by service personnel once a year, in accordance
with the relevant legal regulations. Maintenance includes an emissions analysis
and check of the heating device's efficiency.
- 56 -
Connect gas devices to a gas line using a
special R 1/2" pipe with a minimum internal
circumference of 16 mm.
Use metal connections and a hose or tube.
Use stopcocks or bolts with an internal
circumference at least equal to the internal
circumference of the connection pipe
described above.
After connecting to the gas supply check
that all seals and connections are airtight by
using soap suds or another foam-producing
product to find any leaks.
A