IRTEC smart Manual De Instrucciones página 45

D. Once the flash drive is inserted, the actual update will start, during this stage it is important that
the flash drive is not removed and that the display remains on. The progress bar below shows
the progress of the installation. If installation does not start automatically, the following checks must
be performed:
o Try to insert the USB storage device again.
o Check that the programming files are inside the USB storage device.
o Check the connections of the USB port installed on the back of the display.
E. A summary screen will appear once the installation is complete.
F. Depending on the type of installation, the system may restart from point D or the system will be fully
restarted.
SMART
20/01/2020
85
86
87
45