Manual Setting Of Metres Unwound; Sector And Operating Mode Setting - IRTEC smart Manual De Instrucciones

The same considerations apply as for the initial time with the exception that the countdown starts at the end
of the cycle.
13.4.

Manual setting of metres unwound.

When the system is in STOP mode it automatically calculates the metres of hose unwound by the operator
and instantly shows them on the display. Should it be required to modify them and/or set them because the
unwinding operation has been performed with the device switched off, proceed as follows:

access the main page with device STOPPED (STOP status) and ready to start.

Press the selection wheel/button (the metre box will turn red), if you are in the machine
configuration mode with the option to change the inlet pressure, the pressure box will be
highlighted, simply rotate the wheel and select the metres unwound.

Press the selection wheel/button again (the increase scale will also appear in the F6 key)
F1
F2
F3
F4

Rotate the selection wheel/button until the desired value is reached, the metres will be limited to the
maximum hose length set in the configurations.
NB: during this stage it is NOT possible to command the START (in fact the command has
disappeared from the F1 button).

Press the selection wheel/button again to confirm the position and then prepare for the START.
ATTENTION: if the metres unwound set exceed the metres allowed (configuration parameter paragraph
5.3) the system will progressively decrease it until the maximum value allowed is reached.
13.5.

Sector and operating mode setting.

The sector and operating mode configuration data can always be accessed from the main page using the
F3 key represented by the icon
The only limit of the system is the inability to modify the measurement of the work sectors during operation,
these configurations must be made before the START.
SMART
20/01/2020
139
F5
F6
F7
F8
61