Hach NA5600 Manual De Instrucciones página 25

Option
HOLD OUTPUTS
OUTPUT STATUS
SIMULATE
MEASUREMENT
5.4 Show the analyzer information
To show the analyzer information that follows, push menu, then select VIEW DATA > ANALYZER
DATA. Refer to Table
Item
DATE/TIME
NAME
TYPE
AMBIENT TEMP
CONDITION SOL LEVEL
REACT SOL LEVEL
STANDARD LEVEL
KCL LEVEL
LAST REACTIVATION
LAST CAL
LAST SERVICE
SOFTWARE VERS
DD FIRMWARE
DD CONTENT
SCRIPT VERSION
SCRIPT CONTENT
MEAS_CONTROL SW REV
SERIAL NUMBER
Description
Holds the outputs at the last value or sets them to the transfer value.
ACTIVATION—Select LAUNCH to hold the outputs at the last value or
set them to the transfer value. Select RELEASE to let the outputs
operate normally. SET OUTMODE—Select HOLD OUTPUTS to hold
the outputs at the last value. Select TRANSFER OUTPUTS to set the
outputs to the transfer value. Refer to the operations manual to set the
transfer value for the outputs. SET CHANNELS—Select ALL to select
all of the channels. Select ANALYZER to select all of the channels for
the selected analyzer.
Shows the signals (mA) at the 4–20 mA outputs.
Enters an analyzer reading on a selected channel to do an output test.
The simulation stops after the user exits the screen. SELECT SOURCE
—Selects the analyzer. SET PARAMETER—Selects the channel. SET
SIM VALUE—Sets the analyzer reading.
2.
Table 2 Analyzer data descriptions
Description
Current time (24-hour format) and date identified in the settings
Name of analyzer
Type of analyzer
Ambient temperature of the analyzer
Solution level of the conditioning solution bottle
Solution level of the reactivation solution bottle
Solution level of the calibration solution bottle
Solution level of the KCl electrolyte reservoir
Date the last auto reactivation was done
Date the last calibration was done
Last service date
Software version installed
Version of the device driver firmware installed
Version of the data content of the device driver
Version of the script file directory block
Version of the script file directory content
Revision of the measurement control software installed
Serial number of analyzer
English 25