Mennekes AMTRON Xtra Serie Manual De Instrucciones página 47

The operating mode "Energy Manager" must be enabled
during the setting-up process to become available.
If the operating mode "Energy Manager" is selected,
the following settings must be made via the MENNEKES
Charge APP. They are transmitted to the Energy Manager.
f If necessary, consult a qualified electrician.
Parameter "Battery capacity"
Enter the maximum capacity of the battery of your electric
vehicle.
If the parameter "Battery capacity" is set to
0 kWh, charging in operating mode "Energy
Manager" is not possible.
Parameter "Power demand"
Enter the minimum amount of energy for a charging pro-
cess.
If the parameter "Energy capacity" is set to 0
kWh, charging in the operating mode "Energy
Manager" is not possible.
Parameter "Maximum charging time"
Enter the maximum time for charging the amount of ener-
gy to the vehicle specified with the parameter "energy
demand".
Parameter "Excess charge"
Select the option "Excess charge" if you want to use only
excess energy for charging your electric vehicle.
The parameters "Maximum charging time" and "Power
demand" are then ignored.
The parameter "Battery capacity" is transmitted as an
option.
A minimum charging current of 6A is required
according to IEC 61851-1 for charging.
If the excess energy and the resulting current per
phase are lower than these 6A, the vehicle can
no longer be charged.
In case of connection problems to the Energy
Manager, the charging current is limited to 6A and
the charging process continues.
EN
17