Servicing; Optional Equipment; Operational Problems - Troubleshooting - Jøtul I 600 Instrucciones Para Instalación

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 41
eNglish

7.0 Servicing

Warning! Any unauthorised change to the product is illegal. Only
use original spare parts!
7.1 Replacement of baffle plate – fire
grate and base plate – burn plates
• The baffle plate (Fig. 15), which lies on the burn plates, should
be lifted and tilted down and out of the door.
• Remove the burn plates as described under the installation
of the stove (fig. 8 - 14)
• Lift the fire grate and base plate (fig. 3) up and tilt them
out.
Follow the same procedure for installation, but in the opposite
sequence.

8.0 Optional equipment

Guillotine solution
The guillotine solution is delivered completely mounted in a
package
Assembly instructions are included.
Installation of ash holder (fig. 19 - 20)
1
Attach the included gasket under the edge of the outer
container (se fig. 19A).
2
Lower the outer container down through the bottom of the
fire chamber (20B). and secure using 4 plate screws from the
inside.
3. Place the ash bin in the outer container
32
All manuals and user guides at all-guides.com
9.0 Reasons for operational
problems - troubleshooting
Poor draught
• Check the length of the chimney and that it complies with
• Make sure that there is not anything preventing the smoke
The fire extinguishes after a while
• Make sure that the firewood is sufficiently dry
• Find out whether there is negative pressure in the house, close
• Check that the air vent is open.
• Check that the flue outlet is not clogged by soot
Unusual amount of soot accumulates on the
glass
Some soot will always stick to the glass, but the quantity depends
on:
• Humidity of the fuel.
• The local draught conditions
• Regulating the air vent.
Most of the soot will normally burn off when the air vent is
opened all the way and a fire is burning briskly in the fireplace.«6.1
Cleaning the glass - good advice» .
national laws and regulations. Make sure that the minimum
cross section on the chimney is large enough. See also «2.0
Technical data» and «4.5 Chimney» for information.
gasses from escaping: Branches, trees, etc.
mechanical fans and open a window close to the stove.

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido