Operating Procedures - Hitachi Koki Tanaka TCG 22EAS Instrucciones De Seguridad Y Manual De Instrucciones

Motoguadanas
Ocultar thumbs Ver también para Tanaka TCG 22EAS:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

WARNING
For
Tanaka
heads,
non-metallic
line
manufacturer. Never use wire or wire ropes.
They can break off and become a dangerous
projectile.

OPERATING PROCEDURES

Fuel (Fig. 18)
WARNING
● The trimmer is equipped with a two-stroke
engine. Always run the engine on fuel, which
is mixed with oil.
Provide good ventilation, when fueling or
handling fuel.
● Fuel contains highly fl ammable and it is
possible to get the serious personal injury
when inhaling or spilling on your body.
Always pay attention when handling fuel.
Always have good ventilation when handling
fuel inside building.
Fuel
○ Always use branded 89 octane unleaded
gasoline.
○ Use genuine two-cycle oil or use a mix between
25:1 to 50:1, please consult the oil bottle for the
ratio or Tanaka dealer.
○ Only for the state of California at 50:1.
○ If genuine oil is not available, use an anti-oxidant
added quality oil expressly labeled for air-cooled
2-cycle engine use (JASO FC GRADE OIL or
ISO EGC GRADE). Do not use BIA or TCW
(2-stroke water-cooling type) mixed oil.
○ Never use multi-grade oil (10 W/30) or waste oil.
○ Always mix fuel and oil in a separate clean
container.
Always start by fi ling half the amount of fuel, which
is to be used. Then add the whole amount of oil. Mix
(shake) the fuel mixture. Add the remaining amount
of fuel.
use
only
fl exible,
recommended
by
Fig. 18
Mix (shake) the fuel-mix thoroughly before fi lling the
fuel tank.
the
Fueling
WARNING
● Always shut off the engine before refueling.
● Slowly open the fuel tank, when fi lling up
with fuel, so that possible over-pressure
disappears.
● Tighten the fuel cap carefully, after fueling.
● Always move the trimmer at least 10 ft (3 m)
from the fueling area before starting.
● Always wash any spilled fuel from clothing
immediately with soap.
● Be sure to check for any fuel leakage after
refueling.
Before fueling, clean the tank cap area carefully,
to ensure that no dirt falls into the tank. Make sure
that the fuel is well mixed by shaking the container,
before fueling.
Starting
CAUTION
Before starting, make sure the cutting
attachment does not touch anything.
1. Set ignition switch (20) to ON position. (Fig. 19,
20)
20
English
20
22
Fig. 19
Fig. 20
13

Publicidad

Tabla de contenido
loading

Tabla de contenido