Hitachi Koki Tanaka TCG 22EAS Instrucciones De Seguridad Y Manual De Instrucciones página 18

English
Wind both halves of the line on the reel in the
same direction, keeping each half of the line on
its own side of the partition. (Fig. 36)
4˝ (10 cm)
(4) Push each line into the stopper holes (29),
leaving the loose ends approx. 4˝ (10 cm) in
length. (Fig. 37)
(5) Insert both loose ends of the line through the
cord guide (30) when placing the reel in the case.
(Fig. 38)
NOTE
When placing a reel in the case, try to line up the
stopper holes (29) with the cord guide (30) for
easier line release later.
18
28
Fig. 36
29
Fig. 37
29
30
Fig. 38
(6) Place the cover over the case so that the cap
locking tabs (31) on the case meet the long holes
(32) on the cover. Then push the case securely
until it clicks into place. (Fig. 39)
(7) The initial cutting line length should be approx.
4-11/32˝–5-1/2˝ (11–14 cm) and should be equal
on both sides. (Fig. 40)
Maintenance schedule
Below you will fi nd some general maintenance
instructions. For further information please contact
your Tanaka dealer.
Daily maintenance
○ Clean the exterior of the unit.
○ Check that the harness is undamaged.
○ Check the blade guard for damage or cracks.
Change the guard in case of impacts or cracks.
○ Check that the cutting attachment is properly
centred, sharp, and without cracks. An off -centre
cutting attachment induces heavy vibrations that
may damage the unit.
32
31
Fig. 39
Fig. 40