Starting The Pump - Agilent Technologies Turbo-V 6000 Manual De Instrucciones

17 Technical Information
Monitor Relay Programming

Starting the Pump

If the forepump and vent device are not operated by the controller,
close the vent valve and switch on the forepump.
With the FRONT panel operation selected, the REMOTE and RS 232 operations
NOTE
are inoperative; conversely, the CYCLE NUMBER and PUMP CURRENT push-
buttons are always active, even when the operating mode selected is REMOTE
or RS 232 / 422 / 485.
S
Figure 43
The minus sign (-) become a square ( ) when the pump finish the
ramp-up step. The active step is indicated by a flashing
square ( ).
260/274
Press the START push-button (or use the remote or RS 232 start
signal), and the display shows:
O F T
[ - -
Turbo-V 6000 Controller User Manual / 87-900-855-01 (F)
S T A R T
- - - - -
O N
- - - ]